ProTunerz has been at the forefront of designing and producing forced induction systems for the Nissan L-Series Platform. The most economical way to add SERIOUS power to your L-Series Motor is by Turbo Charging it. Gains from 200-480 HP with the GT3071R. Fully bolt on; with dead accuracy in fitment between wastegate ,downpipe, turbo, and turbo, manifold . Leaving you with no fabrication needed and more time to focus on other aspects of your build.
Our Products have been featured on SEMA builds, ZCon and JCCS winners!Take look at some of our Customer Rides.
Must have to safely boost and tune your Setup 1. Engine Management and Fuel Upgrades. We recommend built motors for over 350hp
Bundle is for ProTunerz Turbo Manifold + Downpipe + Garrett GT3071R + Garrett GVW45
To add Ceramic Coating for Downpipe/Manifold/Turbo Housings add to cart each that applies.
Turbo Manifold
- Construction - Stainless steel, 304 3mm thick TIG welded.
- Custom Flange thick and improvements over stock design.
- T3 Turbo flange Inlet.
- 44mm V-band Wastegate
- Square port flange will seal over round port!
- Will clear Left hand and Right hand steering.
- Will fit s30(240z-280z) and s130 (280zx) models
-
NOT CONFIRMED FITMENT on 280zx 79-81 Power Steering "power recirculating ball" type solution switch to manual rack or 82-83 PS Rack
- AC will also fit
Down Pipe
- 3" Stainless Steel
- BEAUTIFULLY TIG Welded joints.
- Flex Pipe
- 3" V-Band Flange Ends
- Mandrel bent downpipe
- 44mm External waste Re-circulated exhaust pipe and flex pipe.
- s30 DownPipe clears aftermarket transmissions as well 300zx, 350z/370z!
Garrett GT3071R
-
We recommend 0.63 Housing great turbo response and all around optimal performance.
- Original GT Series Aerodynamics
- 53 Compressor
- Dual Ball Bearing
- Oil/Water Cooled CHRA
Garrett GVW45
- CFD tested for maximum flow and thermal efficiency
- Superb reliability thanks to optimized actuation stability and temperature resistance
- Bushing components are fully-replaceable, increasing service life
- Easy Nomex diaphragm replacement
- Watercooled actuator ports (optional)
Also Includes
- 2x 3" Stainless Steel Quick Release Heavy Duty Vbands.
- T3 Stainless Steel Gasket
- 4x SS Turbo Studs/Washers/Nuts
This will also fit the stock intake Manifold as well our ProTunerz intake..
Turbo water line kit coming soon.
Turbo Oil Feed / Drain kit coming soon.
